Separate Grill Underbench Ovens; Separate Grill Wall Ovens; Hard Wiring Detail - Electrolux EOC617 User Manual

installation

separate grill underbench ovens

Recommended Cabinet Design
Note to INStALLeR: For Separate Grill Underbench
Installations where a Cooktop is installed directly above the
appliance, a minimum clearance distance of 10mm must be
allowed for between the bottom of the cooktop & the top of
the Separate Grill Underbench oven.
720mm Module(s)
Bench top
Cleat (2)
Infill panel (2)
Cooker
platform
Kick Panel
8mm
Supporting shelf 8mm below door line
to give perfect alignment of cooker
& cupboard (kickboard notched to suit).
24 INSTALLATION Built-in Cooking
720mm Module(s)
installation

separate grill Wall ovens

Hard Wiring Detail

1. Remove terminal cover plate from rear panel of appliance.
2. Fit wires through hole in cover plate and make connections
to terminals.
3. Engage wires into plastic clip. Secure plastic clip with two
long silver screws (supplied in separate bag).
4. Replace cover plate onto rear panel.
Note: Double oven (Model PDP794). this product is
supplied with two optional termination points. only one
termination point is required to be connected.
Second active wire only
required (optional) for
multi-phase products.
Plastic clips
Plastic clip
securing points.
Built-in Cooking INSTALLATION 25