Table of Contents
Advertisement
13.3 Levelling of the appliance
Use small feet on the bottom of
appliance to set the appliance top
surface level with other surfaces.
13.4 Electrical installation
WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
This appliance is supplied without a main
plug or a main cable.
Applicable types of cables for different
phases:
Phase
1
3 with neutral
WARNING!
The power cable must not
touch the part of the
appliance shaded in the
illustration.
Min. size cable
3x6.0 mm²
5x1.5 mm²
13.5 Covering terminal board
• The recommended cross-section area
is six square millimetres (6 mm²).
• When you refit the mains terminal
cover, make sure that the lower tabs
are located inside the bottom edge of
the aperture, before you fix the two
screws into the top edge of the mains
terminal cover.
• Make sure that the cover is securely
fastened.
To open the cover of
terminal board obey the
procedure in opposite
sequence.
13.6 Terminal board
Do not remove blanking
plates.
Make sure that the links are fitted as
shown.
L
L
N
ENGLISH
29
N
N
Advertisement
Table of Contents
