Change Your Password - ZyXEL Communications XGS1250-12 User Manual

The following table describes the links in the navigation panel.
Table 9 Navigation Panel Links
LINK
System
Port
VLAN
Link Aggregation
Mirroring
QoS
IGMP Snooping
Management

4.4.1 Change Your Password

After you log in for the first time, you must enter a new password using the keyboard characters ("a – z",
"A – Z", "0 – 9", ~!@#$%^&*()_+`–={}[]:;<>./\). The password must be 8 to 15 characters long. To change it,
click Management to display the next screen to change your login password.
Figure 23 Change Administrator Login Password
Chapter 4 Web Configurator
DESCRIPTION
This link takes you to a screen that displays general system information, loop status, and
individual port statistics.
This link takes you to a screen to enable Broadcast Storm Control and Loop Detection/Loop
Prevention. You can also configure advanced settings, such as transmission speed and flow
control on a port.
This link takes you to a screen where you can set the PVID (Port VLAN ID) on a port and create/
modify/delete IEEE 802.1Q VLAN for the Switch.
This link takes you to screens where you can logically aggregate physical links to form one
logical and higher-bandwidth link.
This link takes you to a screen where you can copy traffic from one port or ports to another port
so that you can examine the traffic from the first port without interference.
This link takes you to a screen where you can configure port-based or IEEE 802.1p QoS. The
Switch can put packets into the queues according to the port on which the packet is received
or the priority tag in the packet.
This link takes you to a screen where you can configure IGMP snooping. You must enable IGMP
snooping to use the IPTV service. It checks the IGMP packets passing through it, picks out the
group registration information, and configures multicasting accordingly.
This link takes you to screens where you can change the system login password, perform
firmware upgrade and configuration file maintenance as well as reset/reboot the system. You
can also configure the IP address and subnet mask, set management VID, and enable HTTP/
HTTPS and IEEE 802.3az EEE.
XGS1210-12 / XGS1250-12 User's Guide
28