ZyXEL Communications XGS1250-12 User Manual page 40

Table 10 System (continued)
LABEL DESCRIPTION
Device Name This field displays the name used to identify the Switch on any network.
The device name is a link that you can click to open a screen where you can change the
name. Enter a descriptive name of up to 14 characters. Also, spaces and the following special
characters listed in the brackets ["`<>^$|&;\/:*?'] are not allowed.
Note: You must enter a descriptive name to identify the Switch.
Firmware This field displays the version number and date of the firmware the Switch is currently running.
Version
Loop Status This field displays whether the Switch is in a loop state. It displays Loop when the Switch detects a
loop on one of the ports. Otherwise, it displays Normal.
MAC Address This field displays the MAC address of the Switch.
IP Address The Switch needs an IP address for it to be managed over the network. The factory default IP
address is 192.168.1.3.
This field displays the Switch's current IPv4 address.
Subnet Mask The subnet mask specifies the network number portion of an IP address. The factory default
subnet mask is 255.255.255.0.
This field displays the Switch's subnet mask.
Gateway The field displays the gateway that allows you to send or receive data traffic to or from a
different network than the one the Switch is on.
Per Port Status
Port This identifies the Ethernet port on the Switch.
Link status This field displays the current status or speed of each port. Otherwise, it displays Down.
For XGS1210-12:
• either 10 Mbps, 100 Mbps, 1000 Mbps for ports 1 – 8
• either 100 Mbps, 1000 Mbps, 2.5 Gbps for ports 9 – 10
• either 1000 Mbps or 10 Gbps for port 11 – 12
For XGS1250-12:
• either 10 Mbps, 100 Mbps, 1000 Mbps for ports 1 – 8
• either 100 Mbps, 1000 Mbps, 2.5 Gbps, 5 Gbps, 10 Gbps for ports 9 – 11
• either 1000 Mbps or 10 Gbps for port 12
TX(Pkts) This field shows the number of transmitted frames on this port.
RX(Pkts) This field shows the number of received frames on this port.
Loop Status It displays Loop when the Switch detects a loop on the port. Otherwise, it displays Normal.
Refresh Click this button to update the information in this screen.
Clear Counters Click this button to clear the statistics in the TX(Pkts) and RX(Pkts) fields.
Chapter 7 System
XGS1210-12 / XGS1250-12 User's Guide
40