ZyXEL Communications XGS1250-12 User Manual page 49

Figure 36 Link Aggregation (XGS1250-12)
The following table describes the labels in this screen.
Table 13 Link Aggregation
LABEL DESCRIPTION
Link Aggregation
Link Aggregation Select the outgoing traffic distribution type. Packets from the same source and/or to the same
Algorithm destination are sent over the same link within the trunk. By default, the Switch uses the MAC SA
& DA distribution type. If the Switch is behind a router, the packet's destination or source MAC
address will be changed. In this case, set the Switch to distribute traffic based on its IP address
to make sure port trunking can work properly.
Select MAC SA to distribute traffic based on the packet's source MAC address.
Select MAC DA to distribute traffic based on the packet's destination MAC address.
Select MAC SA & DA to distribute traffic based on a combination of the packet's source and
destination MAC addresses.
Link Aggregation The field identifies the default link aggregation groups the Switch supports. Select which link
Group aggregation group supports your choice in the previous field Link Aggregation Algorithm. For
example, enabling LAG 1: Port 1 and Port 2 and Port 3 and Port 4 will allow packets from the
same source and/or to the same destination to go through ports 1 – 4 for a maximum
throughput of 8 Gbps. This allows for faster speed compared to passing packets through ports 1
– 4 individually (maximum 2 Gbps).
Note: The Switch has a link aggregation group containing ports 1 – 4, ports 5 and 6,
Note: Make sure the ports in a link aggregation group have the same PVID and
Apply Click this button to save your changes to the Switch.
Chapter 10 Link Aggregation
ports 7 and 8, and the other contains ports 9 – 10 (XGS1210-12) / 9 – 11
(XGS1250-12).
VLAN ID.
XGS1210-12 / XGS1250-12 User's Guide
49