Leds - ZyXEL Communications XGS1250-12 User Manual

3.4 LEDs

After you connect the power to the Switch, view the LEDs to ensure proper functioning of the Switch
and as an aid in troubleshooting.
Table 5 LED Descriptions (XGS1210-12)
LED
PWR/SYS
Ports 1–8
LINK/ACT
Port 9
(Left LED)
Port 10
(Right LED)
Port 11
(Left LED)
Port 12
(Right LED)
Table 6 LED Descriptions (XGS1250-12)
LED
PWR/SYS
Ports 1–8
LINK/ACT
Chapter 3 Hardware Panels
COLOR STATUS
Green On
Blinking
Off
Green On
Blinking
Amber On
Blinking
Off
Sky Blue On
Blinking
Green On
Blinking
Amber On
Blinking
Off
Blue On
Blinking
Green On
Blinking
Off
COLOR STATUS
Green On
Blinking
Off
Green On
Blinking
Amber On
Blinking
Off
XGS1210-12 / XGS1250-12 User's Guide
DESCRIPTION
The Switch power is on.
The Switch is starting up.
The Switch power is off.
The port has a successful 1000 Mbps connection.
The Switch is transmitting data through the port.
The port has a successful 10/100 Mbps connection.
The Switch is transmitting data through the port.
The port is disconnected or disabled.
If you enable Loop Prevention in the Port screen, and a loop
happens on two ports, the higher-numbered port will be off.
The port has a successful 2.5 Gbps connection.
The Switch is transmitting data through the port.
The port has a successful 1000 Mbps connection.
The Switch is transmitting data through the port.
The port has a successful 100 Mbps connection.
The Switch is transmitting data through the port.
The port is disconnected or disabled.
The port has a successful 10 Gbps connection.
The Switch is transmitting data through the port.
The port has a successful 1000 Mbps connection.
The Switch is transmitting data through the port.
The port is disconnected or disabled.
DESCRIPTION
The Switch power is on.
The Switch is starting up.
The Switch power is off.
The port has a successful 1000 Mbps connection.
The Switch is transmitting data through the port.
The port has a successful 10/100 Mbps connection.
The Switch is transmitting data through the port.
The port is disconnected or disabled.
If you enable Loop Prevention in the Port screen, and a loop
happens on two ports, the higher-numbered port will be off.
19