Headlamp High/Low-Beam Changer; Flash-To-Pass - Oldsmobile 1995 88 Owner's Manual

If you leave the turn signal on, a chime will sound after
you've driven 3/4 of a mile.
A green arrow on the instrument panel will flash in the
direction of the turn or lane change.
To signal a lane change, just raise or lower the lever
until the green arrow starts to flash. Hold it there until
you complete your lane change. The lever will return by
itself when you release it.
As you signal a turn or a lane change, if the arrows don't
flash but just stay on, a signal bulb may be burned out
and other drivers won't see your turn signal. If a bulb is
burned out, replace it to help avoid an accident. If the
green arrows don't go on at all when you signal a turn,
check the fuse. See "Fuses and Circuit Breakers" in the
Index.
If you have added wiring for the towing a trailer, a
different turn signal flasher may be used. With this
flasher installed, the signal indicator will flash even if a
turn signal bulb is burned out. Check the front, and rear
turn signal lamps regularly to make sure they are
working.
Headlamp High-Low Beam Changer
To change the headlamps from low beam to high or high
to low, pull the turn signal lever all the way toward you.
Then release it.
When the high beams are on, a blue light on the
instrument panel also will be on.
Flash-to-Pass
This feature lets you use your high beam headlamps to
signal a driver in front of you that you want to pass. It
works even if your headlamps are off.
To use it, pull the turn signal lever toward you.
If your headlamps are on, but on low beam, the system
works normally. Just pull the lever until it clicks. Your
headlamps will shift to high beam and stay there. To
return to low beam, just pull the lever toward you.
If your headlamps are on, and on high beam, your
headlamps will switch to low beam. To get back to high
beam, pull the lever toward you.
2-29