Oldsmobile 1995 88 Owner's Manual page 126

Date
Press SEL
v
to select DATEET. Press SEL 4 b if
necessary to display the date. The display will show a
reading such as:
F F U OCTOBER 8
To change the date:
1.
2.
3.
Display the date as described above.
Press and hold
RESET
for about one second until the
display shows MONTH? " D D N Y with
MM/DD/YY representing the date currently stored
in the DIC.
Note: If you allow more than 10 seconds to elapse
between steps, the DIC automatically reverts to the
last date stored in the DIC. You would have to start
this procedure over.
The numbers for the month should be flashing. Press
SEL
v
to decrease these numbers. Press SEL 4 b to
increase these numbers. Press and hold either button
for more than one second to change the numbers
more rapidly. The display will scroll from 01 to 12.
When the month displayed is correct, press RESET
to enter the month.
4.
5 .
The display should show DAY? MM/DD/YY. DD
should be flashing. Using both SEL buttons, set the
day using the procedure described in step 3. The
display will scroll from 1 to 29,30, or 31, depending
on the month selected. When the day displayed is
correct, press RESET to enter the day.
The display should show YEAR? MM/DDNY. YY
should be flashing. Using both SEL buttons, set the
year using the procedure described in step 3. The
display will scroll from 00 to 99. When the year
displayed is correct, press RESET to enter the year.
If a valid date is set, the display will automatically exit
to the date mode. If February 29 is set and the year
selected is not a leap year, the setting will be changed to
February 28.
If the radio is removed or replaced with a non-GM
radio, the DIC will ask for the time before exiting to the
date mode. The procedure for setting the time is very
similar to the procedure for setting the date.