Ecom -AK Operation Manual page 5

Initiation/Measurement
CAUTION
Malfunction of the Readout Process
Exposure to strong light can disturb the readout process.
Protect ecom-AK from strong light.
Different Readout Modes According to Firing Automatic Type
Set firing automatic in diagnosis mode:
• Set firing automatic to diagnosis mode.
NOTICE
Applies only to Siemens burner controls!
Firing Automat in Operating Position:
• Press the reset button on the firing automat for < 3 s.
Firing Automat in Lockout Position:
• Press the reset button on the firing automat for < 3 s.
• Press the reset button again on the firing automat for < 3 s.
Readout
1. Set ecom-AK to the interference suppression button.
2. Enable ecom-AK by pressing the setting key.
NOTICE
With the Satronic or Siemens PC software, hold down the setting key
until PC mode appears on the display.
3. ecom-AK searches for automat information.
NOTICE
When using the AK PC software, the ecom-AK must not be started in
PC mode.
4. ecom-AK switches off after 2 minutes if it does not detect any signal.
5