Table of Contents
Advertisement
QUICK START GUIDE
q 1.1 Setup....................................................................................................................................................
q 1.1.1 Unpack components; compare with the bill of materials................................................................
q 1.1.2 Verify all parts are present...............................................................................................................
q 1.1.3 Identify the assembly and installation fastener bags......................................................................
q 1.2 Partition Assembly................................................................................................................................
q 1.2.1 Remove all the PVC from all the parts, then attach the upper panel to the lower panel................
q 1.2.2 Attach the edge trims on these locations.......................................................................................
q 1.2.3 Attach both wings to the upper and lower panels..........................................................................
q 2.1 Tips on how to attach a plusnut..........................................................................................................
q 2.1.1 Attach plusnut using plusnut gun...................................................................................................
q 2.1.2 Attach plusnut using Ranger plusnut tool......................................................................................
q 2.2 Vehicle preparation..............................................................................................................................
q 2.2.1 Removing handle............................................................................................................................
q 2.2.2 Removing overhead plastic............................................................................................................
q 2.2.3 Driver and passenger sides preparation.........................................................................................
q 2.2.4 Ceiling and floor preparation..........................................................................................................
q 2.3 Contoured partition installation...........................................................................................................
q 2.3.1 Attach the floor bracket in the van.................................................................................................
q 2.3.2 Lift the assembled partition in the van, then bolt both sides of the partition in the van................
q 2.3.3 Attach the upper panel in the van, then attach the lower panel to the floor bracket.....................
q 2.3.4 Apply the warning label on the upper panel...................................................................................
REQUIRED ITEMS
2
PERSONS
For technical support, contact us at 1-800-565-5321
q Cordless Impact
q Cordless Drill
q Knife or Cutter
q Mallet
q Philips Screw Driver
q Plusnut Tool
q Ratchet
q 1/2" Socket
q 7/16" Socket
q 10mm Socket
q 13mm Socket
q T30 Torque Bit
q T40 Torque Bit
q 9/16" Wrench
q 1" Holesaw
C10-PC Installation Guide | REV. D1 | Page 2
3
3
3
4
5
5
6
6
7
7
7
8
8
9
10
11
12
12
13
14
15
Advertisement
Table of Contents
