Laundrylux CROSSOVER 2.0 Series Training Manual page 69

17. Install and tighten the locking-screw that was taken from the stacking bracket in step 12 back
into the bracket through the clearance hole provided in the base of the top dryer.
18. Re-assemble the control console of the top machine and re-connect the CN8 and CN3
connectors of the control board back to machine.
CN3
CN8
19. Route the extended wiring harness from the CN 9 connections through the hole in the base
panel of the bottom control machine (see step 9) and connect the coin meter connector (Red,
White and Blue wires) to the
Control Machines.
20. Once the connections are properly made, mount back the control panel frame and the cross
frame.
21. Before remounting the control, panel reconnect the harness connections.
22. Lock the controller using the service key.
CN9
of the dual coin connections of the Top