Laundrylux CROSSOVER 2.0 Series Training Manual page 35

8. Press START, a two-digit day number ("0d") for which the start day(s) of the week for
promotion
#1 will be displayed. (01=Sunday, 02=Monday, ...07=Saturday, 08=All days,
09=Monday-Friday only, 0A=Saturday and Sunday only, 00=promotion is inactive.)
Edit this number using the DELICATE button to cycle through the allowed values.
9. Press START, the Hours and Minutes in 24 hr. format for the start of Promotion #1
will be displayed (hh.mm). Edit these values using the COLD, WARM, HOT, and
DELICATE buttons.
10. Press START, the promotion percentage discount will be displayed as two digits (%%).
The discount can range from "00" = 0% to "A0" = 100% (e.g. Free Wash). Edit this
number using the HOT and DELICATE buttons. Note, pressing the HOT button ten
times will cycle the value to "A0".
11. Press START to save the changes and exit Register "71"
12. Navigate to Register "72" (RTC Promotion #1 END"). This will allow you to set the
end time for promotion #1.
13. Press START, the promotion end time in hours and minutes in 24 hr. format will be
displayed (hh. min). Edit these values using the COLD, WARM, HOT, and DELICATE
buttons.
14. Press START, this will save the changes and exit register 72.
15. Program the three other Promotion times and percentages as desired using register
pairs: 073 &
074 (Promotion #2), 075 & 076 (Promotion #3), and 077 & 078 (Promotion #4). Each
promotion can have a different percent reduction. They must not overlap with each
other.
16. Exit Service Mode.
PROMOTION PRICING VIA EXTERNAL CLOCK-DRIVEN RELAY OR SWITCH
This washer can apply a Promotion price discount using an external clock-driven relay or
manual switch. To use this, feature the washer requires an optional external price
reduction harness kit be installed. Refer to the product installation manual for information
regarding connecting this signal to the washer to activate discounts.
External Signal and Promotional Firmware Setup
1. Navigate to Register 79 (Promotion %% for discount input signal) as explained in the
Service
Mode section.
2. Press START the promotion percentage discount will be displayed as two digits (%%).
The discount can range from "00" = 0% to "A0" = 100% (e.g. Free Wash). Edit this
number using the HOT and DELICATE buttons. Note, pressing the HOT button ten
times will cycle the value to "A0".
3. Press START, this will save the changes and exit register 79.
4. Exit Service Mode.
When the external signal is activated, the washer will apply a promotion percentage
discount, set in register 79, to the displayed vend price.
Please contact Laundrylux's Technical Support team at (516) 371-0700 if you have any
questions or need assistance with price programming or implementing discount price
programming.