Laundrylux CROSSOVER 2.0 Series Training Manual page 18

Drain Pump (M2)
The drain pump (M2) is a 120-vac electrical pump
located on the bottom of the machine at the front-left.
The filter basket is accessible from the front of the
machine for cleaning either by removing the plastic
caps on the left side of the kick panel on or demounting
the kick panel depending on model.
The machine can be drained using the bleeder hose to
the left of the filter cap.
The pump is connected to the inverter's U1:CN7
Fig 2.17 (M2) Pump
connector. The pump's harness has an inline
connector located near the Service Switch (S2) at the
top of the machine. Voltage and pump-motor winding
resistance can be conveniently measured there.
Level Sensor (B1)
Fig 2.18. Pump Motor Interconnect
The level sensor is mounted to the right side of the
machine and monitors the water level by measuring
the air pressure in the sensor hose connected to the
bottom rear of the outer drum. There are no
adjustments to be made on this component. Water
level adjustments are made through parameter-
entry in the A1 PCB's service mode.
Fig 2.19 (B1) Level Sensor
Anti-siphon hose
The machine has a built-in anti-siphon tube
connecting the drum to the drain hose rear-wall
elbow connection. The tube allows air to fill the drain
hose when the pump is not running, thereby
preventing siphoning of water from the drum.
Fig 2.20 Anti-siphon hose