Advertisement
WARNINGS -
High pressure spray can cause extremely serious injuries such as amputation.
Handle the spray gun as you would a loaded firearm!! Read and understand all instruction manuals, tags,
warnings, users guides & labels supplied with the spray gun, airless pump, hoses, spray tips & any other
attachments before operating equipment.
Learn & follow "Pressure Relief Procedure" of the equipment in use. Never attempt to change or clean the
spray tip or service unit & gun without first releasing pressure. If "Pressure Relief Procedure" is not known,
contact pump manufacturer for instruction.
Never leave pressure in the system while not in use.
Airlessco spray guns are designed for use with Airlessco spray tips only.
If any other attachments are used, the spray gun is considered to be modified and safe operation is now
limited to the safety of the attachment.
For safe renting of airless equipment, use rental instructions, warnings and forms supplied by airless
pump manufacturer
Be sure that all safety devices are operating properly before each use.
PRESSURE RELIEF PROCEDURE
IMPORTANT!
To avoid possible serious body injury, always follow this procedure whenever the sprayer is shut off,
when checking it, when installing, changing or cleaning tips, whenever you stop spraying, or when you
are instructed to relieve the pressure.
1. Engage gun safety latch.
2. Turn unit off and unplug from electrical outlet.
3. Disengage gun safety latch and trigger gun to
relieve residual fluid pressure.
Hold metal part of the gun in
contact with grounded metal pail.
USE MINIMUM PRESSURE !
If the SPRAY TIP OR HOSE IS CLOGGED, follow Step 1 through 5 above. Expect paint splashing into the bucket
while relieving pressure during Step 4.
If you suspect that pressure hasn't been relieved due to damaged Prime/Pressure Relief Valve or other reason,
engage the gun safety latch and take your unit to an authorized Airlessco Service Center.
Manufactured by: AIRLESSCO BY DUROTECH CO.
P.O. Box 8006, Moorpark, CA. 93020-8006, Ship to: 5397 Commerce Ave.,
Moorpark, CA 93021 Tel: 805-523-0211 Fax: 805-523-1063
SUBJECT TO CHANGE WITHOUT NOTICE.
1
Copyright © 2004, Airlessco by Durotech. All rights reserved.
READ FIRST BEFORE USING PRODUCT
4. On Airlessco Model Paint Sprayers turn
Prime/Pressure Relief Valve (PR Valve) to
the open (priming) position to relieve residual
fluid pressure. (PR Valves on sprayers made by other
manufacturers may operate differently.)
There will be a wider gap between valve handle and
cam body when in open position. In the closed
position there is only a very slight gap.
Note: The valve handle can move both clockwise
and counter clockwise and can face different
directions.
5. Re-engage gun safety latch and
close Prime/Pressure Relief Valve.
Advertisement
