Hach SC4500 User Instructions page 8

2.3 Product components
Make sure that all components have been received. Refer to
damaged, contact the manufacturer or a sales representative immediately.
Figure 1 Product components
1 Strain relief, washer and nut
2 USB box connection cable
Section 3 Installation
3.1 Mounting
Use the mounting holes to install the USB box. Do not make holes in the rear of the USB box or
damage to the internal components can occur.
Close the USB box cover and make sure that the cover screws are tight to keep the
environmental rating of the enclosure.
Install the USB box in a location where the power disconnect device for the controller is easily
operated. Install the USB box in the location with the highest Wi-Fi signal strength. Use a mobile
device to find the location with the highest Wi-Fi signal strength.
Attach the USB box to a wall, vertical pole or horizontal pole.
Note: Wall mounting hardware is supplied by the user. Screws/fittings must be suitable for the wall/ceiling
properties and possess sufficient bearing capacity.
2
The pole mounting hardware is for a 40–mm (1.57–inch) diameter pole.
8 English
Figure
3 USB box
4 Pole mounting hardware
N O T I C E
N O T I C E
1. If any items are missing or
2