GMC 1995 Suburban Owner's Manual page 458

1
Maintenance Schedule II
-
Diesel Engines
I
(Contirz~ed)
0
Rotate tires. See "Tire Inspection and Rotation" in the Index for proper
rotation pattern and additional information. See "Tires" in the Index.
13
Check readfront axle fluid level and add fluid
as
needed. Check
constant velocity joints and axle seals for leaking.
4:*
DATE ACTUAL MILEAGE
SERVICED BY:
7 I
60,000 Miles (100 000 km)
0
Change engine oil and filter (or every 3 months, whichever occurs
first). An Eltzission Coutwl Ser-vice.
Lubricate the front suspension, king pin bushings, steering linkage,
transmission shift linkage, transfer case shift linkage, parking brake
cable guides, rear driveline center splines, front axle propshaft splines,
brake pedal springs and clutch pedal springs. Ball joints and king pin
bushings should not be lubricated unless their temperature is I O " F
(-12" C), or higher. When weather is cold, let the ball joints and king
pin bushings warm up before lubrication or they could be damaged.
Perform each of the listed lubrication service items at this mileage
interval (or every 12 months, whichever occurs first).
0
Drain: flush and refill the cooling system with new coolant (,or every 24
months, whichever occurs first). See "Engine Coolant" in the Index for
what to use. An E1uissiou Control
S e r l i c ~ .
Also inspect the hoses and replace them if they are cracked, swollen or
deteriorated. Tighten all hose clamps (except constant tension clamps).
Remove debris and clean the outside of the radiator and air
conditioning condenser. Wash the radiator neck. To ensure proper
operation, pressure test the radiator and cap.
7-90