Rolling Code Programming - Ford 2004 Crown Victoria Owner's Manual

Driver Controls
6. DID NOT TRAIN will be displayed
if the channel did not properly train.
7. Release the channel X button.
Training is complete.
Note: Additional training may be
required for rolling code equipped
devices. Refer to the Rolling code
programming in this section.

Rolling code programming

To train a garage door opener (or other rolling code equipped devices)
with the rolling code feature, follow these instructions after completing
the "Train mode" in this section. (A second person may make the
following training procedures quicker & easier)
1. Locate the "learn" or "smart" button on the garage door motor
head unit. Exact location and color of the button may vary by product
brand. If there is difficulty locating the "learn" or "smart" button refer to
the device's owner manual or contact HomeLink at 1–800–355–3515 or
on the Internet at www.homelink.com.
2. Press and release the "learn" or "smart" button on the garage door
motor head unit.
Note: Following step 2, there are 30 seconds in which to initiate step 3.
3. Press and release the
programmed HomeLink button.
Press and release the HomeLink
button a second time to complete
the training process. (Some garage
door openers may require this
procedure to be done a third time
to complete the training.)
The rolling code equipped device
should now recognize the
HomeLink signal and activate when
the HomeLink button is pressed. The remaining two buttons may now be
programmed if this has not previously been done. Refer to the "Train
mode" in this section.
54
2004 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA English (fus)