Rolling Code Programming - Ford F-250 2012 Owner's Manual

Driver Controls
If you do not know if your garage
door opener is a rolling code or
fixed code device, open your garage
door opener's remote control battery
cover. If a panel of DIP switches is
present your garage door opener is
a fixed code device. If not, your
garage door opener is a rolling code
device.
Note: Programming the Car2U system to a community gate will require
a unique set of instructions depending on the gate system model.
Contact the Car2U help line at 1-866-572-2728 to program your Car2U
system.
Note: Accidentally entering the program mode may override previously
programmed buttons. This can happen by pressing and releasing the
outer two buttons, or all three buttons, simultaneously. If this happens,
do not press any button until the module times out after approximately
2.5 seconds and resets to normal mode. When time-out occurs, all three
LEDs will flash rapidly for a few seconds then turn off. Any settings
should remain as previously set.

Rolling code programming

Note: If you do not follow the time-sensitive instructions, the device will
time out and you will have to repeat the complete procedure.
Note: It may be helpful to have another person assist you in
programming the transmitter.
1. Switch the ignition on.
118
2012 F-250/350/450/550 (f23)
Owners Guide, 4th Printing
USA (fus)
I n f o r ma t i o n P r o v i d e d b y :