Table of Contents
Advertisement
6.2 Alarm – Base – I/O Alarm
Enable / Disable I/O Alarm trigger 1 - 8
Alarm Type: Important or General
Trigger: Low or High trigger (Default is Low for alarm trigger)
For Sensor In:
High Voltage: 5~12V
Low Voltage : 0~2V
Alarm Linkage:
Channel: XDR supports multiple cameras to be assigned for recording when
specific alarm is triggered
Post Recording: Duration of recording to be marked as post alarm event
Lock: Lock specific alarm recording to keep for specified duration – refer to
section 4.3 General > Surveillance > Record > Lock Duration days 1 – 31 days
3G: Applicable only for the XDR-580H
Linkage Output: 1 or 2 – Enable link alarm output when alarm is triggered
Output delay Time: alarm output duration after alarm is removed 0 – 255 secs
Alarm upload: Enable to upload to platform (Only on XDR-580)
Linkage screen: Link channel to show full image when alarm is triggered
PB alarm duration: Available alarm duration after urgent alarm is removed
Alarm snap: Enable to link image snapshot
Alarm – Base Configuration
For Sensor Out:
Triggered Voltage: 12V
Default Voltage:
0V
36
Advertisement
Table of Contents
