Cautions For Handling And Operation - Nakanishi AL-M1202 Operation Manual

Thank you for purchasing the Air Line Kit " AL - M1202 ". This Air Line Kit is designed to adjust the air supply ow
and provide oil mist automatic lubrication to the air tool and reducer. An air motor, reducer, spindle and compressor
are required along with this Air Line Kit.
Read this and all the associated component Operation Manuals carefully before use. Always keep this Operation
Manual in a place where a user can referred to for reference at any time.

1 . CAUTIONS FOR HANDLING AND OPERATION

■ Read these warnings and cautions carefully and only use in the manner intended.
■ These warnings and cautions are intended to avoid potential hazards that could result in personal injury to the
operator or damage to the device. These are classi ed as follows in accordance with the seriousness of the risk.
Class
A safety hazard could result in bodily injury or damage to the device if
WARNING
the safety instructions are not properly followed.
A hazard that could result in light or moderate bodily injury or damage
CAUTION
to the device if the safety instructions are not followed.
WARNING
Handling
①
Connection to the Air Line Kit should be performed by a person with experience with
compressed air and air compressors.
Air Pressure
②
Compressed air is required. Do not exceed an air pressure of 1.0MPa (145psi) at primary side
and 0.85MPa (123.3psi) at secondary side of the Air Line Kit.
Use of Clean Air
③
Do not use compressed air contaminated with chemicals, oil compounds, organic solvents,
salinity or corrosive gasses in order to avoid damage to the device.
Connection of connection hose and supply air / oil hose
④
Connect the input connection hose and supply air / oil hose securely to avoid accidental
disconnection during use. Input air pressure should never exceed 1.0MPa (145psi).
Pressure exceeding 1.0MPa (145psi) may cause the connection hose and supply air / oil hose to
rupture.
Inlet and Outlet Connections
⑤
Do not hit, impact or cause shock to the Inlet or Outlet Connector Connections. Never put
undo stress or load on the Inlet or Outlet Connector Connections. Any damage to these
components can cause air leakage and the inability of the inlet or outlet quick disconnect to
adequately secure the connection hose and supply air / oil hose.
Mounting the Air Line Kit
⑥
When installing the Air Line Kit, securely install the Air Line Kit by mounting it on a at, level
surface. If the Air Line Kit is dropped, damage to the Air Line Kit and injury to the operator is
possible.
Air Regulator Bowl
⑦
The bowl is made of a polycarbonate.
・
Do not use the Air Line Kit in conditions where chemicals or organic solvents are present
in the atmosphere.
Do not remove the bowl guard. Using the Air Line Kit without the bowl guard may cause
・
injury to the operator should the bowl burst.
When removing the bowl from the regulator, remove all pressure from the Input and Outlet
・
sides of the Air Line Kit.
Degree of Risk
11