Nakanishi AL-M1202 Operation Manual page 9

9 . INSTALLATION AND CONNECTION OF THE AIR LINE KIT
CAUTION
The Air Line Kit install to the horizontal. If " Rear Mounting ", install the Air Line Kit to the
horizontally on a vertical wall.
9 - 1 Installation of the Air Line Kit
(1) Horizontal Installation
When the Air Line Kit is mounted from the bottom in a horizontal position Af x the Rubber Pads
(Standard Accessories : 4pcs.) to the bottom of the Air Line Kit.
(2) Rear Mounting or Bottom Mounting
Attach the Air Line Kit by the Mounting Screws (Cross-Recessed Truss Tapping Screw : M6 x 20)
(Standard Accessories : 4pcs) or M6 screw (not included / provided by the end-user) (Fig . 7).
* When Rear Mounting, attach using the Washers (Standard Accessories : 4pcs) between mounting surface
and rear surface of the Base Plate with on horizontal attitude.
4 - 7
20
Bottom Mounting
9 - 2 Connection of the Air Line Kit
(1) Connect the Connection Hose (Standard Accessory) to the Primary Joint of the Air Line Kit.
(2) Connect the Filter Joint of the air motor to the Secondary Joint ( 6 One - Touch Joint) of the Air Line Kit.
(3) Place " Exhaust Air Silencer / Oil Hose " into an empty container. (Exhaust outlet air and oil from the Siliencer.)
Primary Joint
Connector for Air Hose
Connection Hose
To Air Compressor
* The Air Tool is sold separately.
18
（20）
260
2 - 7
20
Rear Mounting
Fig. 7
Spindle
Air Motor
Fig. 8
Base Plate
260 （20）
300
ON / OFF Valve
Secondary Joint
6 One - Touch Joint
Filter Joint
Supply Air / Oil Hose
Exhaust Air / Oil Hose
Silencer