Nakanishi AL-M1202 Operation Manual page 8

8 - 4 Lubricator (Fig. 4)
CAUTION
Make sure to turn the compressed air supply to the Air Line Kit is OFF, before replacing the
・
Lubricating Oil or draining the water in Lubricating Oil.
Check the Lubricating Oil level everyday and before use. If Lubricating Oil level is low, Fill the oil
・
bowl with Lubricating Oil up to the Upper Oil Limit on the bowl.
If collected water in the lubricator taints Lubricating Oil, replace the Lubricating Oil immediately.
・
(1) Oil Amount (Fig. 4)
Check the Oil Amount in the Window.
If the Lubricating Oil level is low, add additional oil (Supply
Lubricating Oil to Upper Oil Level Limit of Fig. 4).
(2) Replacing the Lubricating Oil and draining the water in the
Lubricating Oil (Fig. 4)
Opening and closing the Hand Operating Knob.
O direction : Draining
S direction : Stop Draining.
＜ To divert the Lubricating Oil and drain the water to
another location ＞
Connect a hose with a
provided by the end-user.) to the Oil Outlet Port and divert
to another location.
(3) Adjustment of Oil Drip Rate (Fig. 5)
① Set the air pressure to the air motors recommended
maximum air pressure.
② Adjust the Oil Drip Rate to the recommended
volume which is 1 to 3 drops / min.
(If using the Air Turbine Spindle, adjust the Oil Drip Rate
to the recommended volume which is 1 drops / min.)
O direction : Increase
S direction : Decrease
8 - 5 ON / OFF Valve (Fig. 6)
Turn the ON / OFF lever located on the valve 90-Degrees to
turn the air output ON (Open) or OFF (Close).
6mm I.D. (Not included /
Adjusting Dome
Upper Oil Limit
Lower Oil Limit
O
O : Draining
Hand Operating Knob
Fig. 4
O : Increase
Adjusting Dome
Fig. 5
Lever
OFF (Close)
Fig. 6
Oil Filler Cap
Window
Oil Reservoir
S S
S : Stop Draining
Oil Outlet Port
S : Decrease
ON (Open)
17