Understanding The Display Screen - Carestream DRYVIEW 5700 User Manual

Basic Operating Tasks

Understanding the display screen

Symbol or code Description
Top left of the Error or status code. The 3-digit code displays when the error or status condition is present.
display screen: See
to resolve them. If the laser imager is on and a 3-digit code does not display, the laser
imager is operating normally.
If a different film size has been requested than what is installed, the requested film size
displays. See
Lower left of the Film count. Displays the number of films that are remaining in the film cartridge.
display screen: The loaded film size also displays in this location.
Power When the symbol is green, the power is on and the laser imager is ready to print. The
symbol flashes while the laser imager is processing.
When the symbol is yellow, the laser imager is not ready to print. Examples are when the
laser imager is warming up or when the film cartridge is empty.
Calibrate Press to initiate film calibration. The symbol flashes while the calibration is in process. See
"Calibrating the laser imager for the installed film" on page 2-9
Pause During normal operation, the symbol is off. When the film cartridge cover is open, the
symbol is on. To avoid exposing the film to light, do not open the film supply until the
symbol is off.
If the Pause symbol is on, you can press the symbol to temporarily pause printing. Any
jobs in progress finish printing, then the film cartridge cover closes.
Wait until the Pause symbol is off for cartridge replacement, etc.
Film Size When the symbol appears, the requested job requires a different film size. See
different film size to match a print request" on page 2-7
You can also delete a print request. See
Restart Restart the laser imager. An error code also displays. See
page 2-4
Film Jam Film is jammed. The error code confirms the film jam and gives direction on where to find
the film inside the laser imager. See
Maintenance Preventive maintenance is required. Check the error code to learn what action to take. See
"Preventive maintenance" on page 3-2
2-2
The display screen communicates the status of the laser imager.
"Chapter 3 Maintenance and Troubleshooting"
"Loading a different film size to match a print request" on page 2-7
.
for a complete list of the codes and how
.
"Deleting pending jobs" on page 2-8
"Film jams" on page 3-4
.
9G3886_en
.
.
"Loading a
.
"Restarting the laser imager" on
.
2011-03-31