Riello RS5 Installation, Use And Maintenance Instructions page 19

1. BURNER DESCRIPTION
One stage gas burner.

The burner meets protection level of IP X0D (IP 40), EN 60529.

According to directives: EMC 89/336/EEC - 2004/108/EC, Low Voltage 73/23/EEC - 2006/95/EC and
Machines 98/37/EEC.

Gas train according to EN 676.

The burner is approved for intermittent operation as per Directive EN 676.
Fig. 1
4
0 2 4 6 8 10
1
D10158
1 – Air pressure switch
2 – 6 pole socket for gas train
3 – Control box
4 – Reset button with lock-out lamp
5 – Head holder assembly
1.1 BURNER EQUIPMENT
Flange with insulating gasket . . . . . No. 1
Screw and nut for flange . . . . . . . . . No. 1
Remote reset connection . . . . . . . . No. 1
1.2 ACCESSORIES
MULTIBLOC ROTATION KIT
There is a special kit available that can be used to install the burner turned 180°, as illustrated on page 5 in
position 5 in the section entitled "3.1 WORKING POSITION". This kit is designed to ensure the gas train
valve works properly. The kit must be installed in conformity with laws and local regulations.
20020956
7
10
6 – Pressure test point
7 – Flange with insulating gasket
8 – Air damper adjustment assembly
9 – Servomotor
10 – Motor
Screws and nuts for flange to be fixed to boiler . . . No. 4
7 pin plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
2 GB
5
3
2
6
8
9