Advertisement
1.
Introduction
InRouter 615 is a 4G to Ethernet (4 port) modem/router. This step-by-step guide instructs
how to set up the modem securely for IoT gateway (NETA-21) connections. For technical data
and the manufacturer's documentation, refer to www.inhandnetworks.com.
2.
Scope of the document
This document is intended for use at ABB internal factory line, where the modem and the
NETA-21 gateway are commissioned. The instructions can also be used for commissioning at
the customer's site.
Note: To do the commissioning, the customer needs a SIM card with the mobile data
service enabled and a data plan to avoid data charges from the teleoperator.
Warning!
Obey the safety instructions of the drive. If you ignore them, injury or death, or damage to
the equipment can occur. If you are not a qualified electrical professional, do not do
installation, commissioning, or maintenance work.
Repeat the Electrical safety precautions steps in the drive safety instructions before you start
the work.
This document provides cybersecurity related deployment advice, but please note also the
Cybersecurity disclaimer (Chapter 5).
3.
Connecting the cabling
Connect the power, antenna and ethernet cabling to the modem.
1. Insert the SIM card into the modem.
Note: If the SIM card's PIN code is enabled, several start- ups may lock the SIM card.
Use a SIM card with the PIN code disabled or insert the SIM card just before step 3
"Set up the SIM card" in Chapter 4.
2. Connect the antenna
STATUS
Approved
© Copyright 2021 ABB. All rights reserved.
SECURITY LEVEL
Public
DOCUMENT ID.
3AXD50000837939
I N R O UT ER 6 1 5
REV.
LANG.
PAGE
A
en
2/13
Advertisement
