Bypass Recall Feature; One-Touch Arming; Auto-Arming - Paradox Magellan MG5075 User Manual

Magellan & Spectra SP • Installation Guide

Bypass Recall Feature

After disarming the system, bypass entries are erased. The Bypass Recall feature reinstates the previous bypass entries saved in memory. This eliminates the need to
manually re-program the bypass entries every time you arm your system.
How do I recall bypass entries?
1. Press the [ ] key.
BYP
2. Enter you [ ].
USER CODE
3. Press the [ ] key.
BYP
4. Press the [ ] key.
ENTER

One-Touch Arming

One-Touch arming allows you to arm the system without using a user code. This feature must be enabled by your installer. If One-Touch Arming is programmed, you
can increase the security level of your system (from Disarm
One-Touch Regular Arming
Press and hold the [ ] key to arm all zones in the partition. If partitioned, keys [1] & [2] will flash. You can use this feature to allow specific individuals like service
ARM
personnel (e.g. cleaners) to arm without giving them access to any other alarm system operations. See Regular Arming on page 16.
One-Touch Stay Arming
Press and hold the [ ] key to arm the perimeter (no Stay zones). See Stay Arming on page 16.
STAY
One-Touch Sleep Arming
Press and hold the [ ] key to arm all zones not defined as Sleep zones. See Sleep Arming on page 16.
SLEEP
One-Touch Bypass Programming
Press and hold the [ ] key to access Bypass programming mode. See Bypassing a Zone on page 16.
BYP
Fast Exit
When the system is already Stay or Sleep armed: this feature will allow you to exit already armed premises and keep the system armed. Press and hold the [
for to start the exit delay. After the exit delay has elapsed, the system will switch to its previous arming mode.
Figure 1: Arming / Disarming

Auto-Arming

Timed Auto Arming
The alarm system can automatically arm itself at a specified time every day. As with Regular arming (see Regular Arming on page 16), the system will bypass any
open zones.
How do I program the Auto-Arm Timer?
1. Press the [ ] key.
2. Enter [ ].
MASTER CODE
3. Press the [ ] key. The [
BYP BYP
4. Press key [1] to set partition 1, or press key [2] to set partition 2.
5. Enter the desired time for auto arm (24 hour clock, e.g. 18:30).
6. Press key [1] to regular arm, key [2] to sleep arm, or key [3] to stay arm the partition.
Stay Arm
] key will flash.
Sleep Arm Full Arm) without a code. See Figure 1 below.
] key
OFF
| 17