en Basic operation
Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start / Reload
▶
a The drum rotates and load detection
takes place. This can take up to 2
minutes, after which water enters the
drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended, the
display shows: End.
Soaking laundry
You can soak the laundry before wash-
ing in the appliance by pausing the
programme.
Note: No additional detergent is re-
quired. The soaking solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start / Re-
.
load
To resume the programme, after the
3.
desired soaking time, press Start /
.
Reload
Adding laundry
Note: Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
Press Start / Reload
1.
The appliance is paused and checks
whether it is possible to add or re-
move laundry. Take note of the pro-
gramme status.
→ "Display", Page 20
Add or remove laundry.
2.
Close the door.
3.
Press Start / Reload
4.
36
.
.
.
Cancelling the programme
Once the programme has started, you
can cancel it at any time.
Note: Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
Press Start / Reload
1.
Open the door.
2.
The appliance door remains locked
for safety reasons if the temperature
and water levels are high.
– If the temperature is high, start the
Rinse programme.
– If the water level is high: Start the
Spin or Drain programme.
Remove the laundry.
3.
Resuming the programme
when the programme status
is Rinse Hold
Set the Spin or Drain programme.
1.
Press Start / Reload
2.
Unloading the laundry
Note: Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
Open the door.
1.
Remove the laundry.
2.
.
.