Activating Wi-Fi On The Appliance; Ance; Software Update - Bosch WAV28KH9GB User Manual And Installation Instructions

Press Start / Reload
2.
a The appliance connects to the
Home Connect app.
Once your appliance is displayed in
3.
the Home Connect app, carry out
the last steps in the Home Connect
app.
a If the display shows con, the appli-
ance is connected to the Home Con-
nect app.
Activating Wi-Fi on the appli-

ance

Note: When Wi-Fi is activated, the en-
ergy consumption increases in compar-
ison to the values specified in the con-
sumption value table.
Press and hold Remote Start
1.
approx. 3 seconds.
Set the programme to position 4.
2.
→ "Overview of Home Connect set-
tings", Page 39
a The display shows Con.
Press Start / Reload
3.
until the display shows On.
a Wi-Fi is activated.
Note: If Wi-Fi is activated, the appliance
will not switch itself off automatically.
Deactivating Wi-Fi on the ap-
pliance
Press and hold Remote Start
1.
at least three seconds.
Set the programme to position 4.
2.
→ "Overview of Home Connect set-
tings", Page 39
a The display shows Con.
Press Start / Reload
3.
until the display shows OFF.
a Wi-Fi is deactivated.
.
for
repeatedly
for
repeatedly
Note: If Wi-Fi is switched off and your
appliance was previously connected to
your home network, this connection will
be re-established automatically when
Wi-Fi is switched back on.
Resetting the appliance net-
work settings
Press and hold Remote Start
1.
at least 3 seconds.
Set the programme to position 5.
2.
→ "Overview of Home Connect set-
tings", Page 39
a The display shows rES.
Press Start / Reload
3.
a The display shows YES.
Press Start / Reload
4.
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
Tip: If you wish to operate your appli-
ance again via the Home Connect app,
you will need to reconnect it to the Wi-
Fi and to the Home Connect app.

Software update

Requirement: The display shows Upd.
Press and hold Remote Start
1.
approx. 3 seconds.
Set the programme to position 6.
2.
→ "Overview of Home Connect set-
tings", Page 39
a UdP appears on the display.
Press Start / Reload
3.
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note: The software update may take
several minutes. Do not switch off the
appliance while the software update is
in progress.
Home Connect en
for
.
.
for
.
43