Table of Contents
Advertisement
en Troubleshooting
Problem with results
Errors
Creasing.
The spin result is not satisfact-
ory. The laundry is too wet/too
damp.
Detergent residue on the
damp washing.
Detergent residue on the dry
laundry.
60
Cause
The spin speed is too high.
The load is too large.
The wrong programme is se-
lected for the type of fabric.
A low spin speed is selected.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
Unsuitable detergent added to
the dispenser of the intelligent
dosing system.
Basic dosage is not correctly
adjusted.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
Unsuitable detergent added to
the dispenser of the intelligent
dosing system.
Troubleshooting
The next time you run a wash cycle,
▶
set a lower spin speed.
The next time you run a wash cycle,
▶
reduce the amount of laundry being
loaded.
Select the programmes that are suit-
▶
able for the type of fabric.
→ "Programmes", Page 23
The next time you run a wash cycle,
▶
set a higher spin speed.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Rinse programme.
▶
Check whether the detergent used is
1.
suitable.
→ "Detergents and care products",
Page 32
Drain the dispenser.
2.
→ "Cleaning the detergent drawer",
Page 47
Clean the dispenser.
3.
Refill the dispenser.
4.
→ "Filling the dispenser", Page 37
If intelligent dosing is activated, re-
▶
duce the basic dosage → Page 38.
Brush out the laundry after washing
▶
and drying.
Check whether the detergent used is
1.
suitable.
→ "Detergents and care products",
Page 32
Drain the dispenser.
2.
→ "Cleaning the detergent drawer",
Page 47
Advertisement
Table of Contents
