Connection Of Motor With Encoder (Vector Control) - Mitsubishi Electric 800 Series Instruction Manual

2.9
Connection of motor with encoder (vector
control)
Using encoder-equipped motors together with a vector control compatible option enables speed, torque, and positioning
control operations under orientation control, encoder feedback control, and full-scale vector control.
This section explains wiring for use of the FR-A8AP.
Appearance and parts name of the FR-A8AP
Terminal layout
Symbol Name
a Mounting hole
b Terminal block
Encoder type selection switch
c
(SW3)
d CON2 connector
Terminating resistor selection
e
switch (SW1)
Switch for manufacturer
f
setting (SW2)
g Connector
h LED for manufacturer check
Terminals of the FR-A8AP
Terminal
Terminal name
symbol
PA1 Encoder A-phase signal input terminal
PA2 Encoder A-phase inverse signal input terminal
PB1 Encoder B-phase signal input terminal
PB2 Encoder B-phase inverse signal input terminal
PZ1 Encoder Z-phase signal input terminal
PZ2 Encoder Z-phase inverse signal input terminal
Encoder power supply (positive side) input
PG
terminal
SD Encoder power supply ground terminal
PIN
Not used.
PO
NOTE
• When the encoder's output voltage differs from its input power supply voltage, the signal loss detection (E.ECT) may occur.
• Incorrect wiring or faulty setting to the encoder will cause a fault such as an overcurrent (E.OC[ ]) and an inverter overload
(E.THT).
Correctly perform the encoder wiring and setting.
Front view
(h)
(a)
(d)
(f)
1 O
N
2
SW2
PIN and PO
(c)
are not used.
(e)
(a)
Used for installation to the inverter.
Connected with the encoder.
Switches the encoder type (differential line driver/complementary).
Not used.
Switches ON or OFF the internal terminating resistor.
Do not change from the initially-set status. (Switches 1 and 2 are
OFF .)
1 O
2 N
Connected to the option connector of the inverter.
Not used.
A-, B- and Z-phase signals are input from the encoder.
Input terminal for the encoder power supply.
Connect the external power supply (5 V, 12 V, 15 V, 24 V) and the encoder
power cable. When the encoder output is the differential line driver type, only
5 V can be input. Make the voltage of the external power supply same as the
encoder output voltage. (Check the encoder specification.)

Connection of motor with encoder (vector control)

(a)
SW3
(b) (a)
Description
Description
INSTALLATION AND WIRING
Rear view
(a)
(a)
Refer to
page
―
56
54
―
54
―
9
―
2
53