Section 4 - Hazards; ElectrocutOn Hazard - Mec Speed Level 84RT Series Operator's Manual

Secton 4 - Hazards
ART_3061
ART_3060
DO NOT touch the machine if it contacts energized power lines�����
Personnel in the platform:
• Move away from the platform rails,
• DO NOT attempt to operate the machine, and
• DO NOT touch any part of the machine until energized power lines are shut off.
Personnel on the ground:
• DO NOT approach the machine and
• DO NOT touch or attempt to operate the machine until energized power lines are turned off.
Do not operate the machine during electrical storms or lightning.
DO NOT use the machine as a ground for welding unless properly equipped with a weld line to
platform option.
Page 5
Electrocution Hazard Electrocution Hazard
ELECTROCUTION HAZARD!!! THIS MACHINE IS NOT INSULATED!
DEATH OR SERIOUS INJURY will result from contact with or inadequate
clearance from any electrically charged conductor�����
You must maintain a CLEARANCE OF AT LEAST 10 FEET (3����� 0 5 m)
between any part of the machine, or its load, and any electrical line or
apparatus carrying over 300 Volts up to 50,000 Volts����� One foot (30����� 5 cm)
additional clearance is required for every additional 30,000 Volts�����
Observe Minimum Safe Approach Distance�����
DO NOT work in close proximity to, or in contact with, energized power lines
and electrical equipment. This machine is not insulated and WILL NOT protect
the operator from injury or the machine from damage.
Refer to Table and all applicable governmental regulations for the minimum
safe distances from energized power lines and electrical equipment.
Voltage
Phase to Phase
0 to 300 Volts
Over 300V to 50kv
Over 50KV to 200KV
Over 200KV to 350KV
Over 350KV to 500KV
Over 500KV to 750KV
Over 750KV to 1000KV
84RT Seres Speed Level™ - Operator's Manual
Minimum Safe Approach Distance
Feet
Avoid Contact
10
15
20
25
35
45
July 2021
Meters
3.05
4.60
6.10
7.62
10.67
13.72