Royal Enfield Bullet 500 2018 Owner's Manual page 43

WARNING INDICATIONS & SAFETY SYSTEMS
Do's & Don't's : (ABS)
Do's

While starting the engine do check the ABS indicator
comes ON and switches OFF when the vehicle
speed exceeds 5 km/h (3.1 mph).

Please check the brake fluid at MAX level in the
front and rear brake master cylinders and there is
no leak in the brakes systems
 Apply both the brakes simultaneously for better
efficiency while braking
 In the event of the ABS indicator remaining
continuously ON please take the motorcycle to a
nearest authorized Royal Enfield service station to
inspect the brakes system control of the vehicle.
4. Roll over Sensor
In the event of motorcycle falling over on eitherof
its sides with the engine running and the gears
engaged the Roll over sensor will "disable" both
the ignition and fuel systems and switch 'OFF' the
engine. This is to prevent any damage to the
motorcycle and its rider. To reset the Roll over sensor
and reactivate the ignition and fuel systems.
Don'ts
 DO NOT RELEASE the brake lever/pedal
when pulsations are felt during hard
application of the brakes in an emergency
situation. The pulsations only indicate that
the ABS is activated.

DO NOT APPLY only the front OR rear brake
as it can lead to inefficient braking.
 Ensure the motorcycle is made upright and is
on its center stand.

Ensure gears are in correct neutral and the
neutral lamp is glowing in the instrument
console.

Switch OFF both ignition & stop switches, wait
for a few seconds and switch ON the Ignition
and stop switch again, to start the engine.
42