Table of Contents
Advertisement
10. Then replace the
pressure cap. At any
time during this
procedure if coolant
begins to flow out of
the filler neck,
reinstall the pressure
cap. Be sure the
arrows on the
pressure cap line up
like this.
8. Start the engine and let it run until you can feel the
upper radiator hose getting hot. Watch out for the
engine fans.
9. By this time
the
coolant level inside the radiator
filler neck may be lower. If the level is lower, add
more of the proper mix through the filler neck until
the level reaches the base of the filler neck.
11. Check the coolant in the recovery tank. The level in
the coolant recovery tank should be at the HOT mark
when the engine is hot or at the COLD mark when
the engine is cold.
5-21
Advertisement
Table of Contents
