Table of Contents
Advertisement
Switching the door unlock function
It is possible to set which doors the entry function unlocks.
STEP
1
Turn the "ENGINE START STOP" switch OFF.
STEP
2
Cancel the intrusion sensor of the alarm system to prevent unin-
tended triggering of the alarm during the setting change. (P. 102)
STEP
3
When the indicator on the key surface is turned off, push and
hold
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at
least 5 seconds, and repeat step 3.)
Multi-informa-
tion display
To prevent unintended triggering of the alarm, unlock the doors using the
electronic key and open and close a door once after the settings have been
changed. (If a door is not opened within 30 seconds after
doors will be locked again and the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm. (P. 102)
IS250/220d/200d_EE
1-2. Opening, closing and locking the doors and trunk
or
for approximately 5 seconds while pushing
on the key.
Unlocking doors
Hold the driver's door han-
dle to unlock only the
driver's door.
Hold the front passenger's
door handle to unlock all
doors.
Hold either front door han-
dle to unlock all doors.
Beep
Exterior: Beeps three
times
Interior: Pings once
Exterior: Beeps twice
Interior: Pings once
is pressed, the
1
43
Advertisement
Table of Contents
