Table of Contents
Advertisement
2-2. Instrument cluster
Gear position display
(vehicles with an automatic transmission only)
System check display
After switching the "ENGINE START STOP" switch to IGNITION ON
mode, "CHECK" is displayed while system operation is checked. When the
system check is complete, "COMPLETED" is displayed before returning to
the normal screen.
Outside temperature display
In the following situations, the correct outside temperature may not be dis-
played, or the display may take longer than normal to change.
When stopped, or driving at low speeds (less than 20 km/h [12 mph])
When the outside temperature has changed suddenly (at the entrance/exit
of a garage, tunnel, etc.)
184
IS250/220d/200d_EE
Indicates the current gear, and the range of gears
that is available when the shift lever is in the D
or S position. The gear range is shown by the
number of dots () and the current gear is shown
as a number. The transmission automatically
selects the gears within the driver selected gear
range.
In the illustration to the left, a range of 6 available
gears (1 through 6) has been selected by the driver.
(The shift lever is in the D or S position with 6
ranges enabled.) It is possible for the transmission
to automatically select between all 6 of the gears.
In this case, the transmission has selected third
gear.
Advertisement
Table of Contents
