Table of Contents
Advertisement
From the Fusing Unit
Face-up output: The page goes out of the fusing unit to the tray directly.
Face-down output: The page goes to the inverter before being fed out to
the tray.
Duplexing: The page goes through the inverter to the duplex tray.
This unit is a standard part of the machine, not an optional unit.
For face-up output, the page passes out of the fusing unit to the tray directly.
For face-down output, the page passes to the inverter before being fed out to the
tray.
Platen mode output is face-down by default (can be adjusted) and ADF mode is
always face up (no adjustment). This was discussed in the Operation section of the
course.
For duplexing, the page goes through the inverter to the duplex tray.
Note the trailing edge guide plate, which is a new component for the duplex unit.
Overview
Back into the Machine
Service manual, section 6.13.1
260
260
Advertisement
Table of Contents
