Table of Contents
Advertisement
Paper Size Detection - Trays 2 & 3
Tray 1 does not have a size sensor.
Input the paper size with SP5959 001.
Trays 2 and 3: For the * setting, select the paper size with User
Tools - System Settings - Tray Paper Settings - Tray Paper Size
Only works if SP 5112 is enabled
The service manual shows how the machine interprets the sensor outputs.
Trays 2 and 3 can be set up for a wide range of paper sizes using the ' * ' setting
on the dial, and a User Tool.
The service manual shows the range of settings that can be accepted.
Note SP 5112 however: The machine default is 'disabled' which means the
user cannot use non-standard paper sizes. However, this is changed to
'enabled' at the factory. But if a RAM reset is done, this will revert to
'disabled'.
Also note the use of SP 5129. This tells the machine which paper size to
detect if the dial is at the '11000' position. It only works for inch versions
(North American paper sizes).
207
Service manual, section 6.11.6
207
Advertisement
Table of Contents
