Advertisement
Preparations
Main station
Transport lock: As soon as you have taken the station out of the packaging, the security screw
must be removed. It is located in the middle on the base of the main unit.
The screw is used to secure the pump during transport. It is imperative to remove this screw
before use.
Soldering iron
Attach the solder wire to the soldering iron holder as shown in the picture.
Insert the soldering iron into the 6-pin socket provided on the front of the device (9 in the illus-
tration of the operating elements).
Place the soldering iron on its holder as shown in the illustration.
Soldering fume extraction
1. Connect the soldering fume extractor hose to the socket provided for it (7).
2. Make sure that the hose is not knotted or kinked.
Hot air iron
For packaging reasons, the hot air iron holder is attached to the station the wrong way round
(upside down). Loosen the two screws, turn the holder over and screw it back on.
Desoldering gun
1. Connect the cable to the 6-pin socket on the device (9).
2. Connect the vacuum hose to the socket provided (7).
3. Place the desoldering gun in its holder to prepare for use.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
(1) = direction of solder wire
Item 902703A+
Page 7
03
2021-1
Advertisement
