Table of Contents
Advertisement
Mounting the condensation discharge pipe in the horizontal version (SL-R1 cooling)
-
check that the "L" pipe and the flexible rubber hose are
correctly connected to the bowl.
-
slide in the side of the machine keeping the pipe in position up
against the front grill.
-
fully close the side checking that the pipe remains blocked in
the special grove on the side.
connection pipes
A
Filling the system
When starting up the system, make sure that the hydraulic unit
lockshield is open. If there is no electric power and the thermo-
Evacuating air while filling the system
-
Open all the system interception devices (manual or
automatic);
-
Start the filling by slowly opening the system water filling tap;
-
For the installed in a vertical position, take a screwdriver
and act on the highest breather of the battery; for appliances
installed in a horizontal position, act on the highest positioned
breather.
-
When water starts coming out of the breather valves of the
Venting of the battery
A
N.B. for the horizontal installation carefully note the following
precautions:
-
make sure that the machine is installed perfectly level or with
a slight inclination towards the condensation discharge;
-
insulate carefully the inflow and outflow pipes up to the
machine union to prevent any drops of condensation outside
the same collection bowl;
-
insulate the bowl condensation discharge pipe along all of its
length.
burglary
B
B
A
ø14mm
valve has already been powered use the special cap to press the
valve stopper to open it.
appliance, close them and continue filling until reaching the
nominal value for the system.
Check the hydraulic seal of the gaskets.
It is advisable to repeat these operations after the appliance has
been running for a few hours and periodically check the pressure
of the system.
A
A
GB
11
Advertisement
Table of Contents
