Summary of Contents for Backyard Discovery SAHARA 1804517
Page 1
SAHARA OUTDOOR PRODUCT MODEL: # 1804517 BOOKLET INCLUDES: • Owner's Manual • Frequently Asked Questions • Assembly Instructions • Warranty Information For the most up to date assembly manual, to register your product or to order replacement parts please visit www.backyarddiscovery.com Save this assembly manual for future reference in the event that you need to order replacement parts.
Page 2
Basic Setup Dimensions Place the unit on level ground. Check carefully for overhead lines and ensure there is at least 6 ft [2 m] clearance to any overhead electrical wires. [3658 mm] 12'-5 15/16" [3809 mm] [3658 mm] [1829 mm] 12'-5 15/16"...
Tools Required for Installation: (These are the tools that are generally required for assembly of our outdoor products. These tools are not included with the outdoor product purchase.) (Square) (Level 24") (Phillips Screw Driver) (Rubber Mallet - Optional) (Tape Measure) (3/16"...
Important Note: In the event the INK STAMP identifier is not easy to read or is missing from a wood component, match the unique geometric shape and dimensions of the wood component found in a specific assembly step to the PARTS IDENTIFICATION section when required.
Page 6
Parts Identification Accessories (NOT TO SCALE) - 7x7 POST FOOT - A6P00296 - STEEL POST ANCHORING PLATE WITH FLANGE - A4M00949 - "A" REVISION TAG - A100314 - STEEL POST PLATE - A4M00950 - LTP ID TAG (SMALL) WITHOUT AGES - A4M01010 (2) - T-30 TORX WRENCH - H100114 - GROUND STAKE 16 INCH - A4M00951 (2) - T-30 TORX BIT - H100147...
Page 7
(2) - PT1 - POST - W2A02557 7"x7"x94 1/2" (178x178x2402) (2) - PT2 - POST - W2A02560 - 7x7 POST FOOT - A6P00296 7"x7"x94 1/2" (178x178x2402) STEP 1 SCREW PFH (16) 8x1-1/2 BLK ALL POSTS BOTTOM END WITHOUT PLUG NOTE: CENTER FOOT ON POST 7x7 POST FOOT (4 PLCS)
Page 15
- STEEL POST ANCHORING PLATE WITH FLANGE - - STEEL POST PLATE - A4M00950 A4M00949 STEP 9 LAG SCREW (32) HEX 1/2x2 WASHER (32) FLAT 1/2 BLK LAG SCREW HEX 1/2x2 BLK STEEL POST PLATE (32 PLCS) (8 PLCS) STEEL POST ANCHORING PLATE WITH FLANGE WASHER FLAT 1/2 BLK (8 PLCS) (32 PLCS)
Page 16
- GROUND STAKE 16 INCH - A4M00951 STEP 10 CONCRETE (16) ANCHOR 1/4"x2" WASHER (16) FLAT 8x19 NOTE: IF INSTALLING ON A DECK, YOU MUST ENSURE THERE IS AMPLE STRUCTUAL SUPPORT UNDER DECK. THEN USING POST BASE AS A TEMPLATE, DRILL 3/16" HOLES FOR HARDWARE IN LOCATIONS SHOWN BELOW.
- "A" REVISION TAG - A100314 - LTP ID TAG (SMALL) WITHOUT AGES - A4M01010 STEP 11 SCREW PFH 8x1-1/2 BLK FRONT VIEW SCREW PFH 8x1-1/2 BLK (2 PLCS) LTP ID TAG (SMALL) WITHOUT AGES (1 PLCS) BACK VIEW NOTE: CONSUMER PREFERENCE ON INSTALL.