Advertisement
Available languages
Available languages
Backsplash
K-2333-1 only:
12"
Mark the faucet
(30.5 cm)
supply hole.
Min
Mark the center of
each of the four
drilling holes.
Cut-out
Line
1. Preparation
NOTE: The lavatory center must be located at least 12" (30.5 cm)
from the wall.
Cut out the template along the inside line labeled "Cut-Out."
Position the template on the countertop in the desired location.
Make sure the template is secured firmly in place so it cannot
move.
Verify there is adequate clearance between the lavatory, faucet,
and backsplash.
Trace the inside edge of the template on the countertop with a
pencil.
Mark the exact centers of the four drilling holes.
For K-2333-1 only: Mark the faucet supply hole location.
Drill 5/16" holes at the four marked hole centers.
Cut out the sink hole along the inside of the marked cut-out line.
For K-2333-1 only: Cut or drill the faucet supply hole.
Kohler Co.
Drill a 5/16" hole at
each marked spot.
3
Cut at inside
line.
1096633-2-A
Advertisement
