Table of Contents
Advertisement
PRODUCT AND INSTALLATION OVERVIEW
Featuring durable stainless steel, Kasco's PM-100 Pipe Mount positions CertiSafe™ Tank Mixers securely within the tank for effec-
tive water movement. This manual will provide instructions for mounting a CertiSafe™ unit using the PM-100 and installing the entire
assembly within the tank.
•
Read these instructions thoroughly prior to installation.
•
Contact your CertiSafe™ representative for specific recommendations as necessary.
•
The cord grip and cable support equipment described here are supplied with the mixer unit.
•
To prevent galling, we recommend a moisture-cured, polyurethane compound sealant suitable for contact with potable water and
certified to meet the shrinkage for interior and exterior use. Refer to NSF/ANSI Standard 61 for indirect additives.
•
Be aware of clearance between the mixer assembly and any fixed objects within the tank, including ladders, ensuring that there is
enough room for the CertiSafe™ unit to function correctly and avoid damage to any protective coatings.
•
Please consult your CertiSafe™ sales representative for mixer mount placement, retrieval, and inspection requirements.
Note: some parts will arrive pre-assembled from Kasco; however, all assembly steps are listed for reference.
Pipe:
•
This kit does NOT include a pipe for mounting, as lengths will vary.
•
Pre-cut the appropriate length of pipe prior to installation.
•
A maximum pipe length of 10 feet is advisable. Anything greater will require additional third-party pipe support structures.
•
Once installed, about 1 foot of the pipe length should be above the upper mount assembly.
•
Use 1-1/2" or 40mm (Schedule 40) stainless steel (pipe diameter 1.90" O.D.)
•
The remaining length between the upper and lower mount assemblies will depend on project specifications, but be mindful
that as the pipe length increases, so does the potential for it to yield to deflection from the operating mixer.
•
Must be schedule 40 stainless steel 300 series pipe suitable for NSF 61 applications.
SUGGESTED TOOLS AND SUPPLIES
Electric or cordless drill
3/4" wrench
9/16" wrench
PM-100 CERTISAFE™ PIPE MOUNT
3/8" drill bit
or 1-7/64" (for 10 AWG cord)
Half-round metal file
Side cutter
4
7/8" hole saw
hole saw
Adjustable pliers
Pan to catch shavings
Back to Contents
MANUAL
9/16" socket wrench
3/4" socket wrench
852113 / 2021.1.1
Advertisement
Table of Contents
