Table of Contents
Advertisement
Lower Mount Assembly
1. Slide the lower mount can strap (G) into position on the unit 3" from the cage, ensuring the clamp on the mixer cage is in line with
the can strap flanges.
2. Secure the can strap with a 3/8"-16 x 1" hex head screw
(K), lock washers (L), and nylon lock nut (M). Be sure
that there is a lock washer on either side of the flanges.
3. Position the strut plates (I) and collar blocks (H) together as show below, forming the largest hole for the pipe to pass through.
4. Fasten using two 3/8"-16 x 5" hex screws (J) and nylon lock nuts (M).
J
PM-100 CERTISAFE™ PIPE MOUNT
G
Fig. 11
Fig. 12
I
Fig. 13
Maintain alignment
3 inches
L
K
H
10
Cage clamp
M
M
Back to Contents
MANUAL
852113 / 2021.1.1
Advertisement
Table of Contents
