Table of Contents
Advertisement
CABLE SUPPORT
1. Attach the cable support (U) to the connecting link (R).
2. Close and tighten the connecting link.
U
Fig. 27
4. Continue to feed power cable through the cord grip (S) and out of the tank until
all excess cord length has been taken up, leaving only enough so that there is no
strain on the cable.
5. Tighten the top nut on the cord grip (S) to seal the power cable penetration.
6. Terminate the power cable into an exterior junction box (not supplied by Kasco).
PM-100 CERTISAFE™ PIPE MOUNT
3. Feed power cable through the cable support (U).
R
Fig. 28
S
Fig. 29
14
Back to Contents
MANUAL
852113 / 2021.1.1
Advertisement
Table of Contents
