Table of Contents
Advertisement
Pipe Attachment
1. Pass the cable through the gap between the lower mount collar blocks (H).
2. Pass the length of cable through the center of the pre-cut stainless steel pipe.
Fig. 18
3. Slide the pipe down into position in the strut-block assembly as shown in Fig. 21. Make sure the pipe extends 1 inch through the
collar blocks (H) and does not touch the strut plates below.
4. Tighten all hardware and ensure components are secure to the pipe without over-tightening.
Fig. 20
PM-100 CERTISAFE™ PIPE MOUNT
H
1 inch
Fig. 21
5. Slide the upper mount pipe bracket (B) over the pipe and cable. Ensure the notched
end of the bracket is down (or toward the pipe for a horizontal configuration).
•
For ease of use, about keep about 1 foot of the pipe length above the upper
mount assembly.
6. Attach the upper mount lock handle (C). To prevent galling, apply a small amount of
grease to the threads of the lock handle.
7. Tighten the upper mount lock handle (C) to secure the pipe's vertical position.
B
Fig. 22
12
Fig. 19
Apply grease
Loosen
C
Fig. 23
Back to Contents
MANUAL
H
Tighten
852113 / 2021.1.1
Advertisement
Table of Contents
