Symptoms - Husqvarna Automower105 Operator's Manual

6.5 Symptoms

If your product does not work as expected, follow the symptoms guide below.
There is a FAQ (Frequently Asked Questions) on www.husqvarna.com which provides more detailed answers to a
number of standard questions. Contact Husqvarna
Symptoms Cause
The product has diffi- The guide wire is not laid in a long straight
culty docking. line that is far enough out from the charging
station.
The guide wire is not inserted in the slot un-
der the charging station.
The charging station is on a slope.
The product runs at The product clock needs to be set.
the wrong time
The start and stop times for mowing are in-
correct.
The product vibrates. Damaged blades lead to imbalance in the
cutting system.
Too many blades in the same position lead
to imbalance in the cutting system.
Different versions (thickness) of Husqvarna
blades are used.
The product runs, but The product searches for the charging sta-
the blade disc does tion, or is driving to the starting point.
not rotate.
The product mows Grass or other foreign object blocks the
for shorter periods blade disc.
than usual between
The battery is spent.
charges.
Both the mowing and The battery is spent.
charging times are
shorter than usual.
The product is The product has an inbuilt standby period ac-
parked for hours in cording to the Standby time table. Refer to
Make an estimate of the necessary operating
the charging station.
time on page 22 .
The STOP button has been activated.
36 - Troubleshooting
®
customer service if you still cannot find the reason for the fault.
Action
Check that the charging station has been in-
stalled according to the instructions in
amine where to put the guide wire on page
17
It is absolutely critical for operation that the
guide wire is perfectly straight and is in the
correct position under the charging station.
Therefore make sure that the guide wire is
always in its slot in the charging station. Re-
To install the guide wire on page 19 .
fer to
Place the charging station on a surface that
is entirely level. Refer to
to put the charging station on page 13 .
Set the clock. Refer to
Date on page 24 .
Reset the start time and stop time settings
for mowing. Refer to
ting on page 22 .
Inspect the blades and screws and replace
them if necessary. Refer to
blades on page 28 .
Check that only one blade is fitted at each
screw.
®
Check if the blades are of different versions.
No action. The blade disc does not rotate
when the product is searching for the charg-
ing station.
Remove and clean the blade disc. Refer to
Chassis and blade disc on page 27 .
Replace the battery. Refer to
battery on page 40 .
Replace the battery. Refer to
battery on page 40 .
No action.
Open the hatch, enter the PIN code and con-
firm with the OK button. Press the Start but-
ton and then close the hatch.
To ex-
To examine where
To set the Time &
To reset the timer set-
Replace the
To remove the
To remove the
1285 - 006 - 17.03.2021