Table of Contents
Advertisement
7.
Use the multi-choice buttons to select the days that
the product will operate.
OK .
8.
Push
3.10.3.2 Make an estimate of the necessary operating
time
If the work area is less than maximum product capacity,
the schedule must be set to decrease the wear on the
lawn and the product. The product has a maximum
cutting time each day. You can set the operating time of
the product in the schedule. The operating time includes
cutting, searching and charging. The operating time can
be different because of many reasons, for example the
layout of the work area, the grass growth and age of the
battery. When the product has operated to the maximum
cutting time in a day, the message
complete is shown in the display of the app.
The recommended operating times for some work area
examples are shown in the table below. If the result is
not satisfactory, increase the operating time.
2
Area, m
Recommended operating
time, h
300
6-7
600
12-13
3.10.3.3 To reset the timer setting
You can remove all timer settings and use the factory
setting. The factory timer setting lets the product operate
all hours each day of the week. Refer to
estimate of the necessary operating time on page 22 .
1.
Do steps 1–3 in
To get access to the menu on
page 21 .
2.
Use the multi-choice buttons to move through the
Timer > Reset timer .
menu structure
3.
Push
OK .
3.10.4 Installation
In the Installation menu it is possible to adapt the
settings of the product for best mowing result.
3.10.4.1 Guide width
The guide width is a measure of how far from the guide
wire the product is allowed to travel when it follows this
to and from the charging station. The area beside the
wire which the product uses is called the Corridor.
The product has a default setting for
corridors. To further reduce the risk of tracks forming, it
is recommended to select as wide corridor as possible.
Narrow corridor setting is not normally
The
recommended, but in a garden with one or many narrow
passages, a narrow corridor may be the only option. The
22 - Installation
Narrow corridor setting increases the risk for tracks
forming along the guide.
To set the guide width
1.
2.
3.
4.
3.10.4.2 Remote start 1
The
to remote parts of the work area. If the work area
Today's mowing
includes areas that are connected with narrow
passages, the
to maintain a well-cut lawn in all parts of the yard. The
product begins to mow when it reaches the
point. At all other times, the product leaves the charging
station in the standard manner and starts to mow.
Make an
To set the Remote start function
1.
2.
3.
Medium wide
4.
5.
Do steps 1–3 in
To get access to the menu on
page 21 .
Use the multi-choice buttons to move through the
Installation > Guide width .
menu structure to select
Use the multi-choice buttons to select
Medium or Wide .
OK .
Push
Remote start function is used to guide the product
Remote start function is useful to be able
To get access to the menu on
Do steps 1–3 in
page 21 .
Use the multi-choice buttons to move through the
Installation > Remote start
menu structure to select
> Proportion .
Select how often the
Remote start function shall be
used. There are 5 options:
•
Never (0%)
•
Rarely (approx. 20%)
•
Medium (approx. 50%)
•
Often (approx. 80%)
•
Always (100%)
Select the distance from the charging station to the
Remote start .
OK .
Push
1285 - 006 - 17.03.2021
Narrow,
Remote start
Advertisement
Table of Contents
