Table of Contents
Advertisement
5.3 Replace the blades
WARNING:
the right type. Husqvarna
guarantee safety when using original blades.
Only replacing the blades and reusing the
screw can result in a screw wearing during
mowing. The blades can then be propelled
from under the body and cause serious
injury.
Replace worn or damaged parts for safety reasons.
Even if the blades are intact, they should be replaced on
a regular basis for the best mowing result and low
energy usage. All 3 blades and screws must be replaced
at the same time to obtain a balanced cutting system.
Use Husqvarna
®
original blades embossed with the
crowned H-mark logotype, refer to
page 41 .
5.3.1 To replace the blades
1.
Push the STOP button
2.
Set the Main switch to position
3.
Turn the product upside down. Put the product on
a soft and clean surface to avoid scratching the
product.
4.
Rotate the skid plate so that its holes align with the
screws for the blade.
5.
Remove the 3 screws with a screwdriver.
6.
Remove the 3 blades.
28 - Maintenance
Use blades and screws of
®
can only
Technical data on
0 .
7.
Attach 3 new blades and screws.
8.
Make sure that the blades can pivot freely.
5.4 Battery
WARNING:
using a charging station which is intended
for it. Incorrect use may result in electric
shock, overheating or leakage of corrosive
liquid from the battery. In the event of
leakage of electrolyte flush with water and
seek medical help if it comes in contact with
the eyes etc.
WARNING:
recommended by the manufacturer. Product
safety cannot be guaranteed with other
batteries. Do not use non-rechargeable
batteries.
CAUTION:
The battery must charge a
complete cycle before winter storage. If the
battery is not fully charged it can be
damaged and in certain cases be rendered
useless.
If the operating time for the product is shorter than
normal between charges, this indicates that the battery
is getting old and eventually needs replacing.
Note:
Battery life is dependent on the length of the
season and how many hours a day the product is
operating. A long season or many hours of use a day
means that the battery must be replaced more regularly.
The battery is fine as long as the product maintains a
well-cut lawn.
5.5 Winter service
Take your product to your Husqvarna
for service prior to winter storage. Regular winter service
will maintain the product in good condition and create
the best conditions for a new season without any
disruptions.
Service usually includes the following:
•
Thorough cleaning of the body, the chassis, the
blade disc and all other moving parts.
•
Testing of the product's function and components.
•
Checking and, if required, replacing wear items
such as blades and bearings.
•
Testing the product's battery capacity as well as a
recommendation to replace battery if necessary.
•
If new firmware is available, the product is
updated.
Only charge the product
Use only original batteries
®
central service
1285 - 006 - 17.03.2021
Advertisement
Table of Contents
