Adjustment #1: Wedge Centering - Demtech Pro-Wedge XL Operator's Manual

Rev. D, January 2021
7.2

Adjustment #1: Wedge Centering

a. Adjust the upper and lower contour rollers away from the wedge so they will not
interfere with the wedge centering adjustment. Using a 4mm hex wrench remove the
Lower Contour Roller Adjustment Cover (1) (see Figure 1) to expose the Adjustment
Screw. Using a 10mm box end wrench loosen the Locknut (2) (see Figure 1). Using
a 3mm hex wrench turn the Adjustment Screw (3) (see Figure 1) counter-clockwise,
lowering the Lower Contour Roller Assembly (4) (see Figure 1) away from the Wedge.
Pro-Wedge XL Operator's Manual
Diagram 1
Page 9