Table of Contents
Advertisement
26 April, 2002
Preparation on the PC
1. Set the TCP/IP address for your PC (e.g. 133.139.157.010).
NOTE: NOTE: Do not use the IP address of the printer.
2. Set the Subnet Mask (e.g. 255.255.255.0).
3. Reboot the PC.
Upgrade Procedure
1. Check that the printer front cover is open.
2. Run the Web browser.
3. Type the printer IP address into the Web browser to run Fiery WebTools.
NOTE: The printer IP address is the address you have input in the submenu
Eth. IP Address."
4. Click the Web Downloader button of Fiery WebTool.
5. Click the
Print Connection
0: Direct Connection
6. Browse through the source file list, and select the firmware.
7. Click the
Send file
8. Wait until the
Data In
9. Check that the massages
and
Do Not Power Off
NOTE: Do NOT turn the main switch off before
the messages disappear.
10. Wait until the
Data In
printer reboots automatically.
11. Close the front cover when "Close Front Cover" is displayed.
NOTE: Fiery WebTools does not output any message or indication at the end
of firmware upgrading. Quit Fiery WebTools by clicking the close button
(x) after
12. Check the firmware version by printing Configuration Page.
13. Return all printer settings that were changed in order to perform the upgrade
back to their original values.
button, and select the following option:
button.
LED blinks.
Upgrading System
are displayed.
LED goes out. The
Ready
is displayed.
5-7
FIRMWARE UPDATE PROCEDURE
Upgrading System
Do Not Power Off
G082S912.WMF
Advertisement
Table of Contents
